Manual: AJD610WBP SM PANASONIC EN

© 2002 Matsushita Electric Industrial Co., Ltd. All rights reserved. Unauthorized copying and distribution is a violation of law. . ORDER NO. BSD0202M904 D20 AJ-D610WBP/E/MC Digital Camera/VTR Sec. 1 Service Information Sec. 2 Disassembly Procedures Sec. 3 Electrical Adjustment Sec. 4 Block Diagrams Sec. 5 Schematic Diagrams Sec. 6 Circuit Board Diagrams Sec. 7 Exploded Views & Replacement Parts List for Mechanical Adjustment. BSD0103M901 DVCPRO MECHANISM Version 2 Refer to (CD-ROM No.11/BSD01051K0X) * This mechanism is the same mechanism as AJ- D610WA. Refer to AJ-D610WA Mechanism Adjus

- 2 - AJ-D610WBP ! WARNING This service information is designed for experienced repair technicians only and is not designed for use by the general public. It does not contain warnings or cautions to advise non-technical individuals of potential dangers in attempting to service a product. Products powered by electricity should be serviced or repaired only by experienced professional technicians. Any attempt to service or repair the product or products dealt with in this service information by anyone else could result in serious injury or death.

- 3 -

- 4 -

- 5 - AJ-D610WBE

- 6 -

- 7 -

- 8 - GENERAL GUIDELINES 1. When servicing, observe the original lead dress. If a short circuit is found, replace all parts which have been over-heated or damaged by the short circuit. 2. After servicing, see to it that all the protective devices such as insulation barriers, insulation papers shields are properly installed. 3. After servicing, make the following leakage current checks to prevent the customer from being exposed to shock hazards. LEAKAGE CURRENT COLD CHECK 1. Unplug the AC cord and connect a jumper between the two prongs on the plug. 2. Measure the resistance value, with an ohm